Mr. Heater HST45 Instruções de Operação descarregar pdf (Página 3)

Operating Instructions and Owner’s Manual | Gas-Fired Low-Intensity Infrared Heater

BEFORE YOU BEGIN

Read this manual carefully before installing or servicing this

equipme

nt. Improper installation, servicing or maintenance will

cause death, injury or property damage. Check the minimum

required safe distances from combustibles given on the outside of

each burner to make sure that the product is suitable for your

plication. The minimum required safe distances from

mbustibles is also found on page 9 of this manual. Installer must

a licensed contractor of representative. After the installation is

compl

ete, check product operation as provided in these

instructions

Unpacking the Heater

Manpower Requirements

To prevent personal injury and damage to the heater, two persons

will

be required to remove the heater from the carton. Both ends

the heater should be lifted from the carton at the same time.

The

burner box should be lifted by gripping the bottom of the box.

The

reflector end of the heater should be lifted using the rear

moveable hanger.

Safety

Thin sheet metal parts, such as the reflector portion of the heater

and

the various venting components, have sharp edges. To prevent

inju

ry, the use of work gloves is recommended. The use of gloves

will

also prevent the transfer of body oils from the hands to the

rface of the reflector.

Vent Kit (F102840)

1. (2) 3" x 2' Pipe 26GA.

2. (1) 36" x 3" B-Vent

3. (1) Gas Vent Top 3"

4. (1) Adj. Wall Thimble

5. (1) Storm Collar

6. (1) 3" Elbow

7. (1) Adj. Roof Flashing

Section 1 INTRODUCTION

About The Heater

The MHT/HST 45 is a factory-assembled, gas fired, low-intensity heating

system.

The system has been designed for easy installation and will

provide

years of economical operation and trouble-free service. Not

only

is infrared heat efficient, it also provides the most comfortable

conditions

in open areas, such as garages.

Gas-Fire

d means it uses clean-burning Natural or LP gas.

Low-Intensity means that the radiant surface of the heat

exchanger tube does not glow red. Instead, it operates at a lower

tempe

rature (less than 1000 F) and radiates energy at a lower

intensity per square foot of radiating surface. The lower

tempe

rature and intensity levels are within a range that is most

effective in establishing and maintaining personal comfort levels.

aluminum reflector directs the radiant energy downward to the

occupied

area.

Radian

t refers to the energy radiated by the tube heater. Because

the

energy is in the form of infrared rays, it does not directly heat the

r. Instead, the rays heat objects such as the floor, cars, machines

and

people. The warm objects, in turn, heat the air. These combined

features are the key to the exceptional comfort and fuel efficiency

provided by the tube heater.

Available Accessories

Enerco Group, Inc.,

1 2 3 4 5 6 7 8 ... 23 24

Comentários a estes Manuais

Sem comentários

Mr. Heater HST45 Instruções de Operação Página 3

Comentários a estes Manuais

Manuais e produtos relacionados com Aquecedores elétricos Mr. Heater HST45